Precision Trim Inc.

   A "Precision Product"   

Color Key Door Edge, Fender Trim, Body Side Molding

Installation Instructions

1)    Application area must be clean and dry. Remove any residue with a proper cleaner or degreaser. Clean surface with 70% isopropyl alcohol.

2)    Cut molding to proper length using anvil type pruning shears or equivalent type of cutter.

3)    Pull off 6 inches of red liner and begin to apply molding. With one end           of molding adhered to surface, pull red liner away from molding as you apply the remaining length of trim.

            Note: A.  Apply molding in the proper position on the initial application. This adhesive has a very high bond and should not be repositioned.

                          B. Very Important: After pulling off the red liner, do not touch the gray adhesive with your fingers...hold molding by it's sides.

4)    Use a roller to apply pressure along the entire length of the applied molding. Do this several times, you cannot use to much pressure. The palm of your hand can also be used when a roller is not available.

5)    Allow molding 24 hours to set.

[ Home ] [ Up ]

Copyright © 2006 Precision Trim Inc.
Last modified: 04/28/08